**Problem with Arduino Recognition in SimHub (Device Not Connecting):**
Hi everyone,
I’m facing an issue with SimHub recognizing my Arduino board. Here’s what I’ve done:
1. **Arduino Setup**: The Arduino board is correctly recognized in the **Arduino IDE** setup, and the code uploads successfully without any issues.
2. **SimHub Setup**: In **SimHub**, under the **Arduino Setup** section, the board shows up and I can select it. However, when I go to the **Hardware** section, it shows as **"Not Connected"**.
3. **Loop Issue**: After this, the system gets stuck in a loop with the following messages:
- **"Hello (waiting Arduino boot)"**
- **"Hello (sending)"**
- The loop repeats, and the connection is never established.
**What I’ve Tried:**
- The board is correctly detected in the **Device Manager**, and I’ve confirmed the **COM port** is selected correctly in both the **Arduino IDE** and **SimHub**.
- I've reinstalled the drivers for the **CH340G chip**.
- The **Arduino board is successfully uploading code** without issues.
- I’ve tested different USB cables and ports.
**Additional Information:**
- The Arduino is a [insert model here], and I am using the correct **SimHub sketch** for the setup.
- Despite these steps, SimHub is unable to connect properly and keeps cycling through the loop.
- **Display**: For this project, I am using a **1-inch OLED display** to show car speed and other game data. It’s connected to the Arduino to show useful information for the racing game.
If anyone has encountered this issue or knows how to fix it, your help would be greatly appreciated!