Hello,
I'm pulling my hair out to find a solution to my problem, but I can't. I hope you can help me. I will do my best to give you as much information as possible.
I want to spin PC fans to simulate wind. Everything works outside of Simhub. The motors spin fine when I press the "test" buttons on the Cytron MDD10 board.
As read on the forum, I cut the 5V connection on the board so that it is powered by USB.
I configured Simhub but I have a big doubt about the position of the jumpers on the Cytron MDD10 board and I also have a doubt about the PWM Output in Simhub. My problem may be here. So I need help with this setting.
I tried to put the jumpers PWM1 on 3 and PWM2 on 10 (seen on this forum) and thus the same thing in Simhub but that does not give anything. I tried other combinations, but still nothing.
I also don't know what I should do with the DIR1 and DIR2 jumpers.
I hope you can help me and if you need more information let me know.
I enclose a documentation for the Cytron MDD10, if ever it can help.
Thank you
Unable to put a photo, I put you a pdf with all the photos. Thank you
It's all good. I measured the voltage at the output of the motors when I run a test in Simhub and I had negative voltage. I just reversed the polarities and everything worked.
Thank you.
So I put the jumpers in D3 and D10 on the board and in Simhub.
If you’re dealing with hardware setups and sharing projects, you know how large image files can bog things down. I had a similar problem with some images I needed for a build, and reducing their size was crucial. I came across a super simple guide that helps you quickly shrink images without losing detail. For anyone else facing this, here’s the resource I used: how to change file size of photo. It made file sharing a lot easier for me!