I'm having a strange issue with my setup removed link Setup is as follows:
- 8020 Sim Rig
- Dayton BST-1 transducer front mounted under pedals
- Dayton BST-1 transducer rear mounted under seat
- Nobsound mini 2 channel 100 watt amp
Installed the latest version of Simhub, went to the sound output to test, and the rear channel/shaker works fine, it shakes directly under the seat as it should. When testing the front however, it does not vibrate under the pedals at all or anywhere around them, but rather vibrates to the rear, not directly underneath the seat but more the perimeter of the seat underneath. When I test the rear and physically touch the shaker itself it is clearly vibrating. When I test the front and physically touch the front shaker it is not vibrating. Yet somehow vibration is occurring to the rear during that front test. Very strange. I took the rear shaker out of the equation entirely by disconnecting it from the amp, and tested the front again, it still sends to the rear. It's hard to say at this point of it's some defect in the transducer, Simhub config, or Windows config? It doesn't make sense to me that the front transducer doesn't vibrate to the touch at all yet somehow is sending vibration to the rear.