Error installing simhub on another hard drive with w10. Arduino UNO ATmega 328P

Hi,

I have problems with w10 so I have installed w10 on another disk. 

In the old installation, Simhub went well, Arduino recognizes me. (Now too, if I boot from the old disk)

But in the new installation w10 I get error...

System wide configuration file is "C:\Program Files (x86)\SimHub\_Addons\Arduino\ArduinoIDE\arduino-1.6.13\hardware\tools\avr/etc/avrdude.conf"
Using Port : COM1
Using Programmer : arduino
Overriding Baud Rate : 115200
avrdude.exe: stk500_recv(): programmer is not responding
avrdude.exe: stk500_getsync() attempt 1 of 10: not in sync: resp=0xa6
avrdude.exe: stk500_recv(): programmer is not responding
avrdude.exe: stk500_getsync() attempt 2 of 10: not in sync: resp=0xa6

I have installed different versions of Simhub but it does not recognize the Arduino Board

(I'm sure it has to work because with the old hard drive if it recognizes the board)

  😥 

Any suggestions?

Thanks a lot 🙂