I am using a Radial Gauge to make a flight compass, assembling it with a 357º turn, allowing it to close a circle without overlaping 360º and 0º, and using the Rotation value to make it turn as my aircraft turns, showing my heading.
This is working fine, however, whenever I test or run my dashboard, the gauge only renders every second major tick label, showing me 45º, 135º, and on, but not showing 0º, 90º, and on. These values show up in the work table, but disappear once I hit test or I run the dashboard.
Update:
While messing around with the maximum value and sweep angle, I noticed sometimes the missing values would show up, hoever, the labels would be severely cut off. For example, "315" would show only the lower-most part of the 3, all else would be cut off. I made sure there were no other graphical components cropping them off, and there weren't any.
For the time, I have made the compass work by over-imposing 2 radial gauges, and using one to render the values that were cut off in the other, but the bug remains.