Hi, i'd like to ask if there's any way in simhub to see what exaclty comes to arduino using "custom serial devices" method, cause after opening this in simhub it allocates port and its impossible to open serial monitor in IDE
To view the data being received by the Arduino using SimHub's "Custom Serial Devices" method, you can follow these steps:
1. Open SimHub and go to the "Custom Serial Devices" section.
2. Make sure your Arduino is properly connected to your computer and selected as the output device in SimHub.
3. In the "Custom Serial Devices" section, click on the "Configure" button next to your Arduino device.
4. In the configuration window, you will see a list of data fields that are being sent to the Arduino. These fields represent the data that SimHub is transmitting to your Arduino board.
5. To monitor the incoming data, you can enable the "Debug Mode" option. This will display the data being sent to the Arduino in real-time in the SimHub interface.
6. You can also use the "Test" button to send sample data to the Arduino and see how it responds.
I hope this information can help you.
Thank you it helped a lot 🙂
The biggest help would be info on where "Custom Serial Devices" is?
I've clicked on every page in SimHub - It doesn't exist.
Has it been replaced already, this thread is only 8 months old?
Searching forum has 7 results, none saying where this is? Nothing on youtube
At a complete loss!!
Someone give us a clue?
Thanks in advance!
Look bottom left for Add/remove features, this opens a list of features scroll down until you see Custom serial devices and enable it. Custom serial devices then appears on the left hand list.
Got it thanks