Please could someone tell me
where i need to put the IP address?
I am running project cars 2 on PS4 and nothing in thesimhub (on PC) works. I know its an issue with SIMHUB because RS-Dash works perfectly.
I get the Blue connection logo at the top but no UDP data is being transmitted. Ll i get is laps. That is it, no RPM, no aplit times anything.
Hi ! Have you started simhub before entering the race ? On pcars 2 udp some data are only sent right when you enter the race and are never sent again later, and since simhub does data tracking and needs full opponents data it will only connect only when all the required data has been received. I never tested rs-dash but I guess it's more tolerant to this data "incompleteness" aspect.
Only pcars 2 udp has this specificity and other games like f1xxxx will connect at any time.
Nicolas
Hi, thanks for the reply,
Yeap started sim dash and then started the PS4. It loads up and i when i enter the race i get the blue connection symbol to say it is connected.
I start the race and all i am getting is the track name, time remaining in session and laps completed.
I dont get drivers name, sector times or anything like that.
However on the instructions it says i have to enter my IP address but i can not figure out where i need to enter this? Could this be an issue?
Ok so it will pick up ROM, tyre temps, track conditions but the Map, timing data, best lap, PB all gone.
Its defiantly a simhub issue because RS-Dash displays everything without issues.
Any ideas what is going wrong
I think I understood, RSDAsh uses "pcars1" udp protocol, while simhub is up to date and uses the Pcar2 protocol, could you confirm you correctly configured the game to the "pcars2" protocol in game settings ?
Hi,
Yeap on the PC2. Its odd because it is picking up the car data (RPM, gear etc wtc), it is just not picking up Lap times, sectors etc.