Notifications
Clear all
Topic starter
12/09/2021 8:30 am
The title says it all. I'm unsure if these connectors are used for anything else, but if not, it would be quite useful. I tried ports
(I also asked two smaller questions here, if you could possibly answer, je t'en serais reconnaissant!)
EDIT: I found the answer for my initial question, if anyone stumbles upon this: assigning buttons 0 and 1 did the trick!
This topic was modified 3 years ago 2 times by jongen
30/03/2024 7:11 pm
Hi, I saw your post, could you tell me how to do it as I ran into the same problem as you!
Thanks
01/01/2025 10:28 pm
@fede_villaa Late reply; the solution is just assigning ports number (1) for TX and (0) for RX in the sketch setup menu to your desired inputs.