I recently fitted Simagic Haptic motors to my pedals. There is a tickbox option in the SimHub software marked "Only When Pressed". The idea being that when selected the pedal in question only vibrates when the driver is actually using that pedal. The problem is that when selected all output stops. When deseleted the haptic motors work fine and I can set them up as needed but as soon as I tick those boxes they don't work either in test mode in simhub or in iRacing. I have searched across all forums and only found one other person who had this issue and no one was able to work out how to fix it. I have done all the usual such as uninstall check all documentation etc. Can anyone please help. Thanks.
You need the actual pedals to be plugged to it. Simhub does read directly the inputs from the p1000/2000 controller. If you use it in standalone mode pedals values are not available and so they are never "pressed"
You need the actual pedals to be plugged to it. Simhub does read directly the inputs from the p1000/2000 controller. If you use it in standalone mode pedals values are not available and so they are never "pressed"
Hi Wotever,
Is it feasible to (please) add this feature for the standalone mode? I wouldn't mind if I had to bind a throttle/brake axis and even set a % threshold to tell SimHub what "pressed" means (I assume that's what it would take for this to work).
Thanks!
@admin5435 Thanks for your reply. I am sorry if this is a really dumb question but I thought the simagic haptic motors were plugged in. There are 3 round connectors going from the three motors to the control box and then a single usb cable from that to the PC. Is that not enough? On close inspection I can see three other connectors marked Brake - Throtle - Clutch using small white connectors but it is not clear where these need to be connected to. Is it these that need to be plugged in and if so what connector types are they. Thanks for you assistance.