Hi ! No it's not possible yet, I will look if I can do something 😉

Hi ! Based on the symptoms I see two potentatial causes :- Serial port conflicts between apps, this one is easy to spot, in simhub scan log you will s...

Hi ! I've published a beta version on discord, here is the linkit contains full control of these behaviours as described here :br />

Ah indeed, vcc and gnd must be connected to the arduino otherwise it won't work 😉 That's also why the button 15 will stay on

Hi ! Concerning the button have you tried to check that it's working correctly using a voltmeter in continuity mode ? I faced some issues in the past ...

Actually the game menu indeed acts like a complete game exit because the game simply stops sending telemetry so it's not possible to make a difference...

Hi !This happens for 4 possible reasons :- Game disconnect/reconnect, often VR headsets changes sound output configuration in some sneaky ways and "br...

Hi ! To make easier to configure the bass shakers dedicated sound card master volume (since only the primary one is accessible easily from Windows) ...

Hi ! The message is automatically terminated by "\n" :br />But you have to read the whole message (otherwise it will cause sync issues and disconnect...

Hi ! Mytec C127 also includes a system page as an idle page, when the game will be running and in a race it will automatically switch to the telemetry...

Hi ! Both of them requires a configuration, you can read instructions here :/p>

Hi !You can find instructions about how to change this frequency here :br />Nicolas

Hi ! Unfortunately there is no data given in telemetry, only the configured levels.

@romeo25ah that's stange I don't know from what this picture is from, but indeed the direction can vary depending of how the sketch is written, I adde...

@romeo25It's a good sign,Have you checked the output polarity ? The adafruit test sketch alternate both directions so the fan will always work, but si...