Hi ! It depends of the games, some of them have command line switches (in this case if you go inside game config in simhub you can choose the option i...

Hi ! The motor shield is rated for 1.7amps but your fan is almost the double with 3.3 amps : When it's overloaded the shield will overheat and i...

That's really simple maths 😉 [TrackPositionPercent]*100

Hi ! I don't recommend at all to expose publicly the simhub access, it's not intended for this usage (no authentication or "public exposure" securitie...

(1-[TrackPositionPercent])*100 will do the trick 😉

Hi ! You can use the static wind effect and uncheck "only in game", then on the effect title you can click on the controls icon and set some controls ...

Hi it does not exists as "is" but you can use a simple calculation : (1-[TrackPositionPercent]) * [TrackLength] For the available properties y...

Hi ! At first sight I would say that you haven't telemetry configured in the game, you can find the instructions in simhub when clicking on game confi...

Hi ! Thanks for the feedback, i've disabled recaptcha, could you try again ? Best regards,Nicolas

Hi ! No unfortunately it's a proprietary unit, Simhub has arduino based options. I might invest some time in the future to plug more proprietary devic...

Indeed it has more memory but serial port is as slow as the other Arduinos. The current philosophy is that nothing except pure hardware settings is st...

Hi ! Only "smart LEDs" are supported (ws2812b and pl9823) You can find both in "single" led form factor :/p>

Hi ! I think I've understood your issue, I missed the specific word "screen saver" indeed after the screen is initialised the startup image (which I ...

I confirm that the Arduino is still alive as it's detected, but you probably forgot to enable the motor shield during the sketch setup 😉 currently th...

Hi ! If the Arduino shows as connected inside simhub but showing no motors I would simply think that you forgot to set it at the sketch setup state ...