Hi ! An easy trick is to put in visible binding the rpms> 0 condition. Nicolas

Hello !Une arduino pro micro est vivement recommandée pour cela 😉 Nicolas

Hi !Indeed basic matrix wiring can't support multiple buttons at a time. Currently only this wring is documented and tested for simplicity. I'm not su...

Hi ! Indeed potentiometer are not supported, it requires way more fine-tuning to get a satisfying result (value smoothing, bounds adjustment, response...

@pandanl Yes test now simply sends a small pulse

Hi !Have you tried to push the global gain ? I see it's still on the default 50% but you said your fans would kick at 67% which is not possible to rea...

@did-13003"Arduino micro" and "arduino pro micro" are two different boards, I only support and tested the "pro micro" version, but if I'm not wrong ju...

@did-13003When I built it leonardo clones where still pretty expensive, so I kept focused on cheap versions of all boards (that's also why I won't sup...

Hi ! At first sight, it looks like some crap coming from the serial port, It makes think about bad code in custom protocol but you said it was reset s...

Hi ! Unfortunately this is clearly an hardware issue, this looks like a weak power or weak wiring short, but it's strange those two modules should hol...

@benag Does simhub is properly connected ? The buttons and encoders won't work correctly when simhub is not connected to the arduino. Nicolas

Yes that's the purpose of the setup tool 😉 you will find the Arduino sketch configuration steps here : //github.com/SHWotever/SimHub/wiki/Arduino--Se...

Hi ! If you are using bare encoders (with no resistors) make sure to enable the pullup option in the sketch setup ;)Nicolas

Strange, what is plugged on it ? Could you make sure baudrate is set to 115200 it's the default value which is safe with all arduinos Maybe a dumb q...

Hi !You will find console instructions here :br />Nicolas