Hi ! Yes it's possible, you will just have to setup a custom channel allocation like shown here to be able to separate it output per output :/p>

Hi ! You can use the shell plugin with an autohotkey macro triggered after each lap (see "Controls and events" in simhub to map the action to the newl...

Hi ! System infos have been reworked and centralized, you can read how to configure it here : If you use stock templates information should get back ...

@janm20001 Well you got it right except one small detail, the "0" value will cut the motor it will only start when signal is not 0 so the motor will c...

Hi ! This is indeed a limitation from Iracing. There is no detailed information about slip available so it's roughly estimated based on groud speed/r...

Hi ! You can find the configuration help here : More specifically : 1 - It's gone indeed on effects where it was not significant but you can configur...

Ah nice, so you need to configure your sound card in windows :br />Also check that the drivers don't have their own seettings, on some sound cards lik...

The motors are driven with 12v versus the 5v of the fanatec pedals which makes them react really stronger. About the motors you linked I never had the...

@jared Sorry I mixed the links, the connectivity guide is here :

Hi ! You can follow my previous answer, rpm from 80 to 80 green on leds 1-3 rpm from 85 to 90 yellow on leds 4-6 ... .... rpm from 95 to 100 blue on a...

Hi ! You can find a full troubleshooting guide about game connectivity here : , if everything fails does not hesitate to open a ticket on github joini...

Hi ! Actually it means you simply want to light it above 85%, If you set min and max to 85% it will light all leds at once at the same time starting f...

Hi ! I would suggest keeping with the gamepad rumble motors as shown on the wiki, like these: you can take only left models with the bigger weight.D...

Hi ! This board is not supported out of the box I'm afraid, and sadly it's 4 times more expensive than any other alternatives, so it's it a pretty ba...

Hello ! Malheureusement c'est une limitation hardware de l'arduino, il n'est pas possible de descendre en dessous (avec un bon timing) La limite exac...