Hi ! You can find some advices about this situation in the simhub "nextion end of support notice" available here :/p> Unfortunately itead has been f...

Hi ! Based on the log it's caused by a third pary plugin "EnsiFerrumACC" which miss a file, you need to make sure it's correctly installed or eventual...

Hi ! These options already exists in the effects useful for pedals : it can be implicitly (abs/TC which will only trigger when braking or heavily a...

Hi ! You need to quickly engage and disengage the gear to get it recognized while assigning it.

Hi ! If I'm not wrong open head tracking relies on webcam. I would think about a usb bandwidth issue (usbd480, vocore and all usb screens needs a lot ...

Hi !No, you can read the list of supported games here :/p> I'm currently evaluating expanding to flight simulators in general, if it's successful FS...

Hi ! The feature is experimental, most of the time it will fail to record the screen if the video driver is already busy sending data to another captu...

Hi ! Indeed it's worth splitting both channels (which is only a matter of a single additionnal wire when using PWM fans)Then you can fade the power wh...

Hi ! The underlying basis of the sketch is a simple TTL bridge like this one, This minimal code should be enough : /* leo_usb2serial Allows to...

Hi ! Indeed the session data are corrupted and prevents proper connection for this car. I've released a workaround yesterday which throws out the ...

Thanks a lot ! Lot of coffees 😉 The unfair advantage philosophy is something I've read a few times, I can't remember where to be honest , but it expl...

Hi ! You won't find it unfortunately. Such data is not available from iRacing as it's considered as an "unfair advantage" by iRacing developers. I wou...

Hi it's better not to mix shields and direct connection as they may not work correctly together. Since the Uno can only drive two pwm fans ( one optio...

Hi ! Unfortunately this symptom is typical to a faulty shield, the good test is to simply remove the shield and but still enable it during the sketch ...

Hi ! Yes it's possible :/p>