It's all good. I measured the voltage at the output of the motors when I run a test in Simhub and I had negative voltage. I just reversed the polariti...

@mbrown278 It's all good. I measured the voltage at the output of the motors when I run a test in Simhub and I had negative voltage. I just reverse...

Thank you for your help.I tried with a single Arduino but the result was the same.I have on motors 1, 2, 3 and 4 motors from another Arduino for RPM, ...

I have the same hardware and the same problem. Did you find a solution? Thank you

Unable to put a photo, I put you a pdf with all the photos. Thank you  Wind_En.pdf

Unable to put a photo, I put you a pdf with all the photos. Thank you  Wind_En.pdf

@gazzip Hello. I ask for your help before I do something stupid.I have everything hooked up and when I press the M2B and M1B test buttons on the Cy...